The XLR charger tester is a module specifically designed to measure a wheelchair’s charge/discharge current and battery voltage.
The XLR charger tester is inserted in the connection between the charge device and the wheelchair charge plug. The XLR
charger tester measures voltage from 0.0V to 30.0V and current from 0.0A to 19.9A.

How to use it:
Battery installation
Open the cover on the rear of the housing
Install a 9V battery block (Mind the polarity of the connections!)
Close the cover.

Connection with charge device
Connect the Neutrik female plug to the charge device.

Connection with the wheel chair
Connect the Neutrik male plug to the wheel chair.

Switch on side housing
Middle position: Disconnected.
U position: Measures the voltage on the connection between the charger and the wheelchair.
I position: Measures the current from the charger to the wheelchair.

Disconnection
Disconnect the “Voltage Current Module” after its use in order to prevent the battery from discharging.

XLR Charger Tester
Supply voltage: +9VDC
Rated consumption: 1mA
Measuring range: 0.0V to 30.0V or 0.0A to 19.9A
Accuracy: 5%
Resolution: 0.1
Temperature range: -10ºC to +50°C
Dimensions(W x H x B): 102.5x61.5x26mm
Cable length: 400mm